if
your brand/model not yet listed.
If your turntable model is NOT listed:
If you still have the old belt
intact:
> Lay it out
flat on the table
> Pinch it at
both ends & straighten the belt but don't stretch it.
> Measure the
length & then double it and choose or we will recommend
a size about 3-5% smaller.
Old belt too far gone to measure:
> Just use a piece of string and
thread it temporarily in place of where the belt goes.
> Then measure the length of the
string and Email
us the exact length (inches). Along with your EXACT model number.
If your belt has a
round or square cross section, please give us the thickness as well.
We can assist
you in choosing a
belt usually 3-5% smaller than the length you measured. EXAMPLE:
You measure
25" on your turntable
with a string.....we will recommend a 23.6" belt, NOT a 25" belt as there
must
be some tension for
your belt to work.
Email us if you have a tape deck, reel to reel, VCR, answering machine,
etc.
EXAMPLE: You measure 25" on your
turntable with a string.....we will recommend
a 23.6" belt, NOT a 25" belt
as there must be some tension for your belt to work.
Most
PROJECT 1 models NOT listed use Belt Part# FBM 25.0"(63.5cm)
'Flat Belt Medium' Width=.187"(3/16")
to .203"(13/64") (4.8-5.2mm)
FBM 23.6"(60cm)
| Project 1 |
| DR-2A | DR-115 | DR-331 | DR1 |