We are sure you will love our new website, but if you prefer, you may still scroll down to use our old website. We have all research areas completely intact for our past customers who may prefer to use the navigation style with which they are familiar. New visitors may find the simple listing of part numbers on our old site valuable until we get all these lists transferred to the new site.
If your turntable model is NOT listed:
If you still have the old belt intact:
> Lay it out flat on the table
> Pinch it at both ends & straighten the belt but don't stretch it.
> Measure the length & then double it and choose or we will recommend
a size about 3-5% smaller.
Old belt too far gone to measure:
> Just use a piece of string and thread it temporarily in place of where the belt goes.
> Then measure the length of the string and Email us the exact length (inches). Along with your EXACT model number.
If your belt has a round or square cross section, please give us the thickness as well. We can assist
you in choosing a belt usually 3-5% smaller than the length you measured. EXAMPLE: You measure
25" on your turntable with a string.....we will recommend a 23.6" belt, NOT a 25" belt as there must
be some tension for your belt to work.
Email us if you have a tape deck, reel to reel, VCR, answering machine, etc.
Most CHANNEL MASTER models NOT listed use Belt Part# [No dominant size for this Brand]
'Flat Belt Medium' Width=.187"(3/16") to .203"(13/64") (4.8-5.2mm) FBM 17.0"(43.1cm)