We have any size you could need for your Turntable.

If your model is NOT listed:
> If intact, measure the entire length of your old belt.
   (Do this by laying the belt flat on the table, similar to above pic, pinch it at
    each end and pull it straight from each end without stretching it. Measure
    the length and double your result.) We can assist  you in choosing a belt
    usually 3-5% smaller than the length you measured.

or
> Just use a piece of string and thread it temporarily in place of
   where the belt goes in the turntable.
> Then measure the length of the string  and Email us the exact length (inches).
   Along with your EXACT model number.
> If your belt has a round or square cross section, please
   give us the thickness as well.  We can assist  you in choosing a belt
   usually 3-5% smaller than the length you measured.

EXAMPLE: You measure 25" on your turntable with a string.....
we will recommend a 23.6" belt, NOT a 25" belt as there must
be some tension for your belt to work.